REVOX G-36 II

Magnétophone à bande
1967 Stéréo à lampes
2 pistes ou 4 pistes stéréo
Bandes jusqu'à 27cm
différencié du premier modele par le détecteur de fin de bande, les vis sur le cache têtes et le capot arriere entre autre ...

Tape speed

3 3/4 and 7 1/2 ips, pole-switching capstan motor, direct drive (motor may be switched off, if recorder is used as an amplifier)

Flutter and wow

below ± 0,1% at 7 1/2 ips

Rewind time

approx. 80 seconds of a 2400 feet reel

Max. reeldiameter

up to 25 cm (10 1/2")

Frequency response

40 - 15'000 cycles at 7 1/2 ips +2/-3 db
40 - 12'000 cycles at 3 3/4 ips +2/-3 db

Equalization

in accordance with CCIR standards.
70 micro-seconds at 7 1/2 ips.
140 micro-seconds at 3 3/4 ips.

Signal to noise ratio

Better than 52 db at peak record level (2 track)
Better than 50 db at peak record level (4 track)

Dynamic range (overall)

2-track recorder:

55 db at 7 1/2 ips

53 db at 3 3/4 ips

4-track recorder

52 db at 7 1/2 ips

50 db at 3 3/4 ips

(Thd.= 3%)

Crosstalk

Mono 55 db

stereo 40 db

Oscillator-bias frequency

70'000 cycles,

push-pull oscillator

Inputs per channel

1. microphone

= 1 Megohm, 3 mV

2. Radio

= 1 Megohm, 50 mV

3. Diode

= 47 K'ohms, 3 - 50 mV, adjustable

Outputs

2 cathode-follower outputs, impedance = 5'000 ohms (input impedance of amplifier to be connected should be higher than 100'000 ohms.)

Output voltage
= 0.6 volts - (2 track)
= 0,4 volts - (4 track)

1 loudspeaker output 5 ohms, 6 watt Push-pull power amplifier, internal speaker may be switched off.

Tube complements

4 x ECC 81, 1 x ECC 82, 5 x ECC 83, 2 x ECL 86, 1 x EM 801,
3 diodes, 3 selenium rectifiers

Power line voltage

110, 240 volts, 50 cycles

Power requirements

approximately 120 watt

Fuses

for 220-240 volts: 0.6 Amps) 5 x 20 mm slow-blow
for 110-145 volts: 1,2 Amps) 5 x 20 mm slow-blow

All these data are valid for the 2-track as well as the 4-track recorder, unless noted otherwise.